Guardian Equipment is pleased to introduce the fundamentally safe emergency eyewash station GFR3200. This heated safety station features an eyewash and a top intake. It is suitable for use in a Class I Division 1 environment.
Features:
- Class I Division 1
- Floor mounted electrically heat traced emergency eyewash station with a top inlet
- ABS plastic showerhead with internal 20 GPM flow control
- 1” IPS U.S. made stay-open brass ball valve with stainless steel actuating arm
- ½” IPS U.S. made 3-way self-draining stay-open brass ball valve
- 1¼” IPS Schedule 40 hot-dipped galvanized pipe and fittings
- Stainless steel flag handle and powder-coated cast aluminum floor flange
- UV-resistant ABS plastic jacket with foam insulated core and weather-sealed with elastomeric material
- 120VAC and 60 HZ single phase power supply
- Pipe sensing thermostat
- Trace indicator light included
Application: Class I, Division 1 rated electric heat-traced stations prevent freezing in extremely hazardous, cold weather conditions where flammable gases are routinely expected. Thermostat-regulated units are heated by a self-limiting heat-tracing cable wrapped around the internal pipe. Units are intended for cold weather use down to -40°F. See ‘Tempering Valves’ section to ensure tepid water compliance with ANSI Z358.1-2014.
Heating Cable: Self-regulated with external termination guards. When the internal piping temperature drops below 50°F, the thermostat activates, UL, and CSA approved for Class I, Division 1, Groups B, C, and D.
Electrical System: The unit is fully wired at the factory. Junction box and components rated for Class I, Division 1, Groups B, C, and D. Requires 120 VAC single-phase power supply. Heat-trace indicator light included. Note: In order to meet Class I, Division 1 requirements, approved conduit, and fittings must be used during installation.
Jacket/Insulation: UV-resistant orange ABS plastic with polyethylene foam insulation. Jacket sections are secured with removable stainless steel screws for easy maintenance.
Shower Head: 10” diameter orange ABS plastic with 20 GPM flow control.
Shower Valve: 1” IPS brass stay-open ball valve. US-made with brass ball and PTFE seals. Including stainless steel actuating arm and 29” stainless steel pulls rod.
Spray Head Assembly: Freeze-resistant with float-off dust covers and internal flow control.
Eyewash Valve: 1/2” IPS brass three-way self-draining stay-open ball valve. US-made with brass ball and PTFE seals. Includes 1/2” NPT port to drain water from spray heads after use.
Pipe And Fittings: Schedule 40 galvanized steel.
Supply: 1-1/4” NPT female top inlet.
Sign: ANSI-compliant identification sign.
Quality Assurance: Factory tested prior to shipment. Ships fully assembled and crated.
Shipping: For this specialized unit, expect lead time to be around 6-7 weeks
Specifications:
| Available Options | |
| SSH | Stainless steel shower head |
| GRN | Green ABS plastic shower head and shell |
| HV | 240 volt heat-tracing |
| TL | Heat-trace indicator light |
| SP | Scald protection valve. |
| FP | Freeze protection valve |
| ALC | Clear Area Light (ships separately from unit) |
| G3800LF Thermostatic mixing valve | Note: Must be installed in a non-freezing environment. |
Offshore RigMan88 –
Excellent construction for Class 1 Division 1 hazardous areas.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal